Could anyone give me some pointers on correct procedure of installing
throttle / gear control cables for an outboard.
Control box is single lever which operates a gear cable and throttle
cable.
In the full astern position :-
throttle half open and gear in reverse
as the lever is moved forward :-
throttle closes and gear lever moves forward towards neutral
In lever middle (neutral) position then the throttle is in idle and gear
is
in neutral
as the lever is moved further forward the gear engages to ahead and the
throttle starts to move ahead.
Could anyone give me some tips on proper procedure for adjusting the
control
cables length so that the engine
1. does not stall when gear is engaged
2. is not over revving when the gear is engaged
??
